Note AcademyNote Academy

Chemistry YCH11 · Chapter 12

Introduction to kinetics and equilibria

Collision theory, rates of reaction and how to measure them, Maxwell-Boltzmann distributions, catalysts, dynamic equilibrium, and the effect of conditions on the position of equilibrium.

5 min read

Download this chapter (PDF)

Collision theory and rate

For a reaction to occur, particles must collide with at least the activation energy, EaE_a (the minimum energy needed to start a reaction), and with the correct orientation. Most collisions do not result in reaction.

The rate of reaction is the change in concentration of a reactant or product per unit time (mol dm−3^{-3} s−1^{-1}).

Factors affecting the rate

FactorEffect and explanation
Concentration (or pressure of a gas)More particles per unit volume, so more frequent collisions and more successful collisions per second
Surface area of a solidMore particles exposed, so more collisions per second
TemperatureParticles move faster so collide more often, but mainly a much greater proportion have energy ≥Ea\geq E_a
CatalystProvides a different route with a lower activation energy

Calculating rate

  • From the time taken: rate ∝1/t\propto 1/t.
  • From a graph: the rate at a given time is the gradient of the tangent to the concentration–time (or volume–time) curve at that time. The initial rate is the gradient at t=0t = 0.

Maxwell–Boltzmann distribution

The distribution shows the number of molecules with each energy at a given temperature.

  • The curve starts at the origin (no molecules have zero energy), rises to a peak and falls, but never touches the axis.
  • The area under the curve is the total number of molecules, and is the same at all temperatures.
  • EaE_a is marked on the energy axis. The area to its right is the number of molecules able to react.

Raising the temperature: the peak moves to the right and is lower; the curve is flatter. The area beyond EaE_a increases a lot, so a much greater proportion of molecules can react.

Catalysts

A catalyst speeds up a reaction without being used up, by offering an alternative reaction route of lower activation energy. On the diagram, mark a second EaE_a to the left; more molecules have energy above it, though the distribution of energies is the same.

A reaction profile shows enthalpy against progress. A catalysed route has a lower peak, and if the catalyst forms an intermediate, two lower peaks with a dip between them. The enthalpy change ΔH\Delta H is unchanged.

Catalysts make industrial processes more sustainable because they work at lower temperatures (less energy used, fewer emissions) and can allow reactions with a higher atom economy.

Dynamic equilibrium

Many reactions are reversible (⇌\rightleftharpoons). In a closed system the reaction reaches dynamic equilibrium when:

  • the rate of the forward reaction equals the rate of the reverse reaction, and
  • the concentrations of reactants and products stay constant.

Both reactions are still happening.

Le Chatelier's principle

If a system at equilibrium is subjected to a change, the position of equilibrium shifts to oppose the change.

ChangeShift
Increase in concentration of a reactantTowards the products
Increase in pressureTowards the side with fewer moles of gas
Increase in temperatureIn the endothermic direction
Decrease in temperatureIn the exothermic direction
CatalystNo change in position (the rates of both directions rise equally)

High pressure shifts the equilibrium to the right (4 moles of gas to 2), increasing the yield. High temperature shifts it to the left (the endothermic direction), reducing the yield.

Compromise conditions

Industrial processes balance the yield and the rate. In the Haber process (about 450 °C, 200 atm, iron catalyst) a lower temperature would give a better yield but too slow a rate, and a higher pressure would give more ammonia but would be costly and a safety risk. A compromise is used.

Test yourself10 flashcards on this chapter.Flashcards →

These notes are AI generated and may contain mistakes. Check them against your syllabus.