Brønsted–Lowry theory
A Brønsted–Lowry acid is a proton donor. A base is a proton acceptor. Acid–base reactions involve proton transfer.
A conjugate acid–base pair differ by one proton. In the pairs are and .
pH
with in mol dm. A change of one pH unit is a tenfold change in .
Strong and weak acids
A strong acid is fully dissociated (HCl, , for the first proton). A weak acid is only partly dissociated (ethanoic acid), so is much less than the concentration of the acid.
For a strong monobasic acid, . A 0.020 mol dm solution of HCl has .
Ka for a weak acid
For :
A larger (smaller ) means a stronger acid.
pH of a weak acid
Two assumptions are made:
- , because the dissociation of water is negligible, and
- , because the acid is only slightly dissociated.
mol dm. .
from experimental data
Measure the pH of a solution of known concentration (or known mass in a known volume). Then and .
The ionic product of water
In pure water so . increases with temperature (water ionisation is endothermic), so the pH of pure water falls below 7 when it is hot, but it is still neutral.
pH of a strong base
for NaOH. Then .
. .
Experiments on strong and weak acids
- Equimolar solutions of a strong and a weak acid have different pH, but neutralise the same amount of alkali.
- Diluting a strong acid by 10, 100 and 1000 times raises the pH by 1, 2 and 3. A weak acid pH changes by less than 1 unit per tenfold dilution, because dilution also increases its degree of dissociation.
- Salts can be acidic (), alkaline () or neutral () depending on whether the ions are conjugates of weak acids or bases.
Titration curves
Plot pH against volume of base added.
| Titration | Start pH | Equivalence point | Vertical region | Suitable indicator |
|---|---|---|---|---|
| Strong acid + strong base | Low (1) | 7 | pH about 3–11 | Methyl orange or phenolphthalein |
| Weak acid + strong base | Higher (about 3) | Above 7 (about 8–9) | About 7–11 | Phenolphthalein |
| Strong acid + weak base | Low | Below 7 (about 5) | About 3–7 | Methyl orange |
| Weak acid + weak base | Higher | About 7 | No sharp change | None suitable |
Diprotic acids (e.g. or ethanedioic acid) show two steps in the curve if the values are different enough.
Buffer solutions
A buffer solution resists changes in pH when small amounts of acid or alkali are added (or when it is diluted).
- An acidic buffer is a weak acid with its salt (a source of the conjugate base), e.g. ethanoic acid with sodium ethanoate.
- A basic buffer is a weak base with its salt, e.g. ammonia with ammonium chloride.
How a buffer works
In an ethanoic acid / ethanoate buffer, :
- Adding : the ethanoate ions (a large reservoir) react with the added , forming ethanoic acid, so the position moves to the left, and barely changes.
- Adding : reacts with to form water, and the acid dissociates to replace the , so the position moves to the right.
pH of a buffer
. .
Use the same equation to find the concentrations or the mass of salt needed to prepare a buffer of a particular pH.
Buffering in a titration curve
In a weak acid–strong base titration the buffer region is the gently sloping part before the equivalence point. At the half-equivalence point, half the acid has been neutralised, so and
This gives a method for finding from the pH at the half-neutralisation point. Core Practical 11 uses it: titrate a weak acid with a strong base, find the equivalence volume, add half that volume to a fresh sample and measure the pH.
Importance of buffers
- In blood, the buffer keeps the pH at about 7.4.
- Cells contain buffers (phosphates and proteins) because enzymes work only in a narrow pH range.
- In foods, buffers stop the pH changing because of bacterial or fungal activity, which delays spoilage.
These notes are AI generated and may contain mistakes. Check them against your syllabus.

