Alcohols
Alcohols contain the group, with the general formula . They are named with the suffix -ol and a locant: propan-1-ol, propan-2-ol, 2-methylpropan-2-ol.
- Primary: the carbon bonded to is attached to one other carbon ().
- Secondary: attached to two other carbons ().
- Tertiary: attached to three other carbons ().
Reactions of alcohols
Combustion
Halogenation
| Reagent | Product | Notes |
|---|---|---|
| (solid, room temperature) | Chloroalkane, and steamy fumes of HCl | Also a test for the –OH group |
| Sodium or potassium bromide with 50% concentrated sulfuric acid | Bromoalkane | forms in the flask, heated under reflux |
| Red phosphorus and iodine | Iodoalkane | forms in the flask |
Dehydration
Heating with concentrated phosphoric acid (or concentrated sulfuric acid, or passing vapour over hot aluminium oxide) removes water and forms an alkene by elimination: .
Oxidation
Acidified potassium dichromate(VI) (orange) is an oxidising agent that turns green as forms. In equations the oxidising agent can be written .
| Alcohol | Conditions | Product |
|---|---|---|
| Primary | Distil off the product as it forms | Aldehyde |
| Primary | Heat under reflux with excess oxidising agent | Carboxylic acid |
| Secondary | Reflux or distil | Ketone |
| Tertiary | — | No reaction (the colour stays orange) |
Tests on the products
- Aldehydes give a brick-red precipitate with Benedict's or Fehling's solution (on warming), and a silver mirror with Tollens' reagent. Ketones do not.
- Carboxylic acids give effervescence with sodium carbonate or sodium hydrogencarbonate, giving off carbon dioxide.
Techniques for preparing a liquid
Heating under reflux
The mixture is heated in a flask fitted with a vertical condenser. Vapours condense and return to the flask, so the reaction can be heated for a long time without loss. Add anti-bumping granules, and use an electric heater or a water bath rather than a flame for flammable liquids. The water flows into the condenser at the bottom and out at the top, so the jacket stays full.
Distillation
The mixture is heated in a flask with a still head, thermometer and downward condenser. The component with the lowest boiling temperature distils over first. The thermometer bulb is level with the side arm so that it measures the temperature of the vapour. Distillation is used to separate a product from the reaction mixture and to purify it, and the temperature range at which the product comes over is a check on its purity (boiling temperature determination).
Solvent extraction
Shake the mixture with a second, immiscible solvent in a separating funnel. Release the pressure by opening the tap with the funnel inverted. Let the layers separate. The organic layer lies above water if its density is lower, and below if the density is higher. Run off the lower layer through the tap.
Drying
Add an anhydrous salt such as anhydrous magnesium sulfate, sodium sulfate or calcium chloride to the organic liquid and swirl. It takes up water. Add more until the solid no longer clumps and the liquid is clear. Filter or decant the dried liquid.
Reflux (reaction); distil to separate the crude product; wash the distillate with sodium hydrogencarbonate in a separating funnel; dry with an anhydrous salt; then do a final distillation and collect the fraction at the boiling temperature of 1-bromobutane (102 °C).
Core Practical 7: oxidation of propan-1-ol
Two products are made in two experiments from propan-1-ol with acidified potassium dichromate(VI):
- Propanal by distillation: add the alcohol dropwise to the heated oxidising mixture and distil off the propanal as it forms, so that it is not oxidised further.
- Propanoic acid by reflux: heat the mixture for a longer time under reflux, then distil to collect the acid.
Tests: the aldehyde gives a positive Benedict's test and the acid gives carbon dioxide with sodium carbonate.
These notes are AI generated and may contain mistakes. Check them against your syllabus.

