Note AcademyNote Academy

Physics YPH11 · Chapter 26

Refraction and total internal reflection

Refractive index, Snell's law, the critical angle and total internal reflection, Huygens' construction for diffraction, and the pulse-echo technique.

4 min read

Download this chapter (PDF)

Refraction

When a wave crosses the boundary between two media its speed changes. If it meets the boundary at an angle, its direction changes too. This is refraction. Frequency stays the same, so a change of speed means a change of wavelength.

Refractive index and Snell's law

The refractive index of a material is

n=cvn = \frac{c}{v}

where cc is the speed of light in a vacuum and vv the speed in the material. Air has n≈1n \approx 1, water about 1.33 and glass about 1.5.

At the interface between medium 1 and medium 2, Snell's law gives

n1sin⁡θ1=n2sin⁡θ2n_1 \sin\theta_1 = n_2 \sin\theta_2

with both angles measured from the normal.

sin⁡θ2=1×sin⁡40°1.33=0.483\sin\theta_2 = \dfrac{1 \times \sin 40°}{1.33} = 0.483, so θ2=28.9°\theta_2 = 28.9°. The ray bends towards the normal in the denser medium.

Measuring the refractive index of a solid

Pass a ray through a rectangular block, measure the angle of incidence θ1\theta_1 and the angle of refraction θ2\theta_2 for several values, and plot sin⁡θ1\sin\theta_1 against sin⁡θ2\sin\theta_2. The gradient is nn.

Total internal reflection

When light goes from a denser to a less dense medium it bends away from the normal. As the angle of incidence increases, the refracted ray moves towards the boundary. At the critical angle CC the angle of refraction is 90°.

n1sin⁡C=n2sin⁡90°⇒sin⁡C=n2n1(for air outside: sin⁡C=1n)n_1 \sin C = n_2 \sin 90° \quad\Rightarrow\quad \sin C = \frac{n_2}{n_1} \quad\left(\text{for air outside: } \sin C = \frac{1}{n}\right)

For angles of incidence greater than CC there is no refracted ray. All the light is reflected: total internal reflection.

sin⁡C=11.50=0.667\sin C = \dfrac{1}{1.50} = 0.667, so C=41.8°C = 41.8°.

50°>41.8°50° > 41.8°, so the light is totally internally reflected and does not emerge.

Uses

Optical fibres guide light by repeated total internal reflection along a core with a higher refractive index than its cladding. Prisms in binoculars and reflectors use it too.

Diffraction and Huygens' construction

Huygens' construction treats every point on a wavefront as a source of secondary wavelets. The new wavefront is the line tangent to the wavelets after a short time.

When a wave passes through a gap, the wavelets spread out into the region behind the edges. This is diffraction. It is greatest when the gap is about the same size as the wavelength.

For a diffraction grating, nλ=dsin⁡θn\lambda = d\sin\theta gives the angle of the nnth-order maximum for a grating of line spacing dd.

Pulse-echo

In the pulse-echo technique a short pulse of waves (ultrasound, radar, sonar) is sent out and the time tt for the echo to return is measured. The distance to the reflecting object is

d=vt2d = \frac{vt}{2}

because the pulse travels there and back. A string of pulses scanned across a body gives a map of the boundaries inside it.

d=1500×60×10−62=0.045d = \dfrac{1500 \times 60 \times 10^{-6}}{2} = 0.045 m, or 4.5 cm.

Test yourself8 flashcards on this chapter.Flashcards →

These notes are AI generated and may contain mistakes. Check them against your syllabus.