Note AcademyNote Academy

Physics YPH11 · Chapter 25

Fluids, viscosity and strain energy

Upthrust, viscous drag and Stokes' law, terminal velocity in a fluid, and the elastic strain energy stored in a stretched material.

4 min read

Download this chapter (PDF)

Upthrust and viscous drag

Upthrust

A body in a fluid feels an upward force, the upthrust, equal to the weight of fluid it displaces:

U=ρfluid VgU = \rho_{\text{fluid}}\, V g

where VV is the volume of fluid displaced. A body floats when its weight equals the upthrust.

U=900×4.0×10−6×9.81=3.5×10−2U = 900 \times 4.0 \times 10^{-6} \times 9.81 = 3.5 \times 10^{-2} N.

Viscous drag

An object moving through a fluid feels a viscous drag that opposes the motion and grows with speed. For a small sphere moving slowly in a fluid, Stokes' law gives

F=6πηrvF = 6\pi\eta r v

where η\eta is the viscosity of the fluid, rr the radius of the sphere and vv its speed. The law holds for slow, smooth (laminar) flow only.

Terminal velocity of a falling sphere

A sphere dropped into a viscous liquid speeds up until the forces balance. At terminal velocity the acceleration is zero:

weight=upthrust+viscous drag\text{weight} = \text{upthrust} + \text{viscous drag}

mg=U+6πηrvtmg = U + 6\pi\eta r v_t

Writing the mass in terms of the sphere's density ρs\rho_s and the liquid's density ρl\rho_l gives

43πr3(ρs−ρl) g=6πηrvt⇒vt=2r2(ρs−ρl)g9η\tfrac{4}{3}\pi r^3 (\rho_s - \rho_l)\, g = 6\pi\eta r v_t \quad\Rightarrow\quad v_t = \frac{2r^2(\rho_s - \rho_l)g}{9\eta}

η=2r2(ρs−ρl)g9vt=2×(1.5×10−3)2×6600×9.819×0.060=0.54 Pa s\eta = \frac{2r^2(\rho_s - \rho_l)g}{9v_t} = \frac{2 \times (1.5 \times 10^{-3})^2 \times 6600 \times 9.81}{9 \times 0.060} = 0.54 \text{ Pa s}

The falling-ball method

Release a ball just below the surface and time it over a measured distance far enough down that it has reached terminal velocity. Repeat for balls of different radius. A graph of vtv_t against r2r^2 is a straight line through the origin, and the gradient gives η\eta.

Stress, strain and energy stored

A material is described by:

  • Stress =FA= \dfrac{F}{A} (Pa), the force per unit cross-sectional area.
  • Strain =Δxx= \dfrac{\Delta x}{x} (no unit), the extension per unit original length.
  • Young modulus E=stressstrainE = \dfrac{\text{stress}}{\text{strain}} (Pa), for a material that obeys Hooke's law.

Hooke's law gives F=kΔxF = k\Delta x up to the limit of proportionality. Beyond the elastic limit, the material does not return to its original length.

Elastic strain energy

The work done in stretching a material is stored as elastic strain energy. It is the area under the force-extension graph:

Eel=12FΔx=12k(Δx)2E_{el} = \tfrac{1}{2}F\Delta x = \tfrac{1}{2}k(\Delta x)^2

When the graph is a curve, estimate the area by counting squares or splitting into strips.

Eel=12×80×2.0×10−3=0.080E_{el} = \tfrac{1}{2} \times 80 \times 2.0 \times 10^{-3} = 0.080 J.

Test yourself8 flashcards on this chapter.Flashcards →

These notes are AI generated and may contain mistakes. Check them against your syllabus.