Note AcademyNote Academy

Biology YBI11 · Chapter 4

Gas exchange, cell membranes and transport

Gas exchange surfaces and Fick's law, the mammalian lung, membrane structure and the fluid mosaic model, osmosis, and passive and active transport.

5 min read

Download this chapter (PDF)

Gas exchange surfaces

An efficient gas exchange surface has:

  • a large surface area to volume ratio,
  • a thin barrier (short diffusion distance, often one cell thick),
  • a steep concentration gradient maintained by ventilation and blood flow.

Fick's law

rate of diffusion∝surface area×difference in concentrationthickness of the exchange surface\text{rate of diffusion} \propto \frac{\text{surface area} \times \text{difference in concentration}}{\text{thickness of the exchange surface}}

So doubling the surface area doubles the rate, while doubling the thickness halves it.

The mammalian lung

  • Trachea, bronchi and bronchioles carry air to the alveoli. The trachea has rings of cartilage that keep it open and ciliated epithelium and goblet cells that remove mucus and trapped particles.
  • Alveoli: millions of tiny air sacs lined with a single layer of squamous epithelium, which gives a large surface area and short diffusion distance.
  • A dense network of capillaries around each alveolus also has walls one cell thick. Together, the alveolar and capillary walls are about 0.5 μm thick.
  • Ventilation (breathing) maintains a high O2O_2 concentration and low CO2CO_2 concentration in the alveoli, and blood flow removes oxygen and brings carbon dioxide, so the gradients are steep.
  • Elastic fibres in the walls recoil on breathing out. Surfactant reduces surface tension to stop alveoli collapsing.

Cell membranes

Structure: the fluid mosaic model

The fluid mosaic model describes the membrane as a phospholipid bilayer with proteins scattered in it like a mosaic, and the molecules free to move sideways (fluid).

  • Phospholipids have a hydrophilic head (phosphate, facing the water) and hydrophobic tails (fatty acids, facing inwards). The bilayer is a barrier to water-soluble substances.
  • Intrinsic (integral) proteins span the bilayer. They include channel proteins and carrier proteins, and receptors and enzymes.
  • Extrinsic (peripheral) proteins are on one surface.
  • Cholesterol fits between phospholipids and regulates fluidity, reducing it at high temperature and preventing the membrane becoming too rigid at low temperature.
  • Glycoproteins and glycolipids have carbohydrate chains on the outer surface for cell recognition and signalling.

The model is an interpretation of data: it was developed from electron microscope images and experiments (such as the movement of labelled proteins between fused cells) and has been modified as new evidence appeared. The earlier Davson–Danielli model (a protein-lipid-protein sandwich) did not fit the data.

Core Practical 3: membrane permeability

Beetroot cells contain a red pigment, betalain, in the vacuole. If the membrane is damaged the pigment leaks out.

  1. Cut equal pieces of beetroot, rinse, and place each in the same volume of water or solution.
  2. Vary the temperature (or the concentration of alcohol), keeping other variables constant.
  3. After a set time, measure the colour of the liquid with a colorimeter (or compare with standards).

Higher temperatures denature the membrane proteins and make the phospholipids move more, so the permeability increases and more pigment leaks out. Ethanol dissolves the lipids in the membrane and has the same effect.

Movement across membranes

Diffusion and osmosis

Diffusion is the net movement of molecules from a region of higher concentration to lower concentration, down a concentration gradient. It is passive and needs no energy.

Osmosis is the net movement of free water molecules through a partially permeable membrane, from a region of higher water potential to a region of lower water potential.

  • Pure water has the highest water potential, ψ=0\psi = 0. Solutes make it more negative.
  • A cell placed in a solution of lower water potential loses water. Animal cells shrink (crenate). Plant cells become plasmolysed as the membrane pulls from the wall.
  • In a solution of higher water potential, an animal cell may swell and burst (lyse). A plant cell becomes turgid, held by the cell wall.

Passive transport

ProcessHow it works
Simple diffusionSmall, non-polar molecules (O2O_2, CO2CO_2) pass directly through the phospholipid bilayer
Facilitated diffusionPolar molecules and ions pass through channel proteins (gated, specific) or carrier proteins (change shape). Down a gradient, no ATP

Active transport

Active transport moves substances against a concentration gradient using ATP (the immediate source of energy) and carrier proteins. The carrier binds the substance, ATP is hydrolysed and the carrier changes shape to release it on the other side. It can be selective, and is inhibited by respiratory poisons.

Bulk transport

  • Endocytosis takes material into a cell: the membrane folds in and pinches off a vesicle. Phagocytosis takes in solids and pinocytosis takes in liquids.
  • Exocytosis releases material: a vesicle fuses with the membrane (e.g. secretion of enzymes and hormones).

Both need ATP.

Test yourself10 flashcards on this chapter.Flashcards →

Practise this chapter

Every past-paper question on these topics, with the mark scheme.

These notes are AI generated and may contain mistakes. Check them against your syllabus.