Note AcademyNote Academy

Biology YBI11 · Chapter 20

Culturing microorganisms and measuring their growth

Aseptic culture techniques, ways of measuring microbial growth, the bacterial growth curve and growth rate constants, and Core Practical 13.

4 min read

Download this chapter (PDF)

Culturing microorganisms

Microorganisms are grown in a laboratory in liquid broth or on solid agar containing a suitable nutrient medium. Aseptic technique prevents contamination by unwanted microbes and prevents the culture escaping.

  • Sterilise equipment and media by autoclaving (steam under pressure at 121 °C for 15 minutes), and the inoculating loop by flaming.
  • Work near a Bunsen flame (the updraught carries airborne microbes away), and keep lids on as much as possible.
  • Wash hands, disinfect the bench, and wear gloves and a lab coat.
  • Seal dishes with tape (not fully), incubate inverted at a safe temperature (25 °C in schools), and autoclave cultures before disposal.

Measuring growth

MethodWhat it measuresNotes
Cell counts (haemocytometer, under a microscope)The total number of cells, living and deadQuick, but cannot tell live from dead (unless a stain is used)
Dilution plating (viable count)The number of viable cells, as colonies on agarSerially dilute the sample, spread a known volume on agar, incubate and count the colonies. Number per cm3^3 = colonies × dilution factor / volume plated. Each colony is assumed to come from one cell
Mass (dry mass)The biomass of the cultureFilter, dry and weigh. Destroys the sample
Turbidity (optical methods)The cloudiness of a liquid culture using a colorimeter or spectrophotometerQuick, but includes dead cells and is not sensitive at low densities

Serial dilution

A serial dilution reduces the concentration by the same factor at each step (e.g. 1 cm3^3 of culture into 9 cm3^3 of sterile water gives a 10-fold dilution each time). If a plate prepared from the 10−410^{-4} dilution has 45 colonies from 0.1 cm3^3, the original has 45×104×10=4.5×10645 \times 10^{4} \times 10 = 4.5 \times 10^{6} cells per cm3^3.

The bacterial growth curve

A graph of log (number of viable cells) against time shows four phases:

PhaseWhat is happening
LagCells adapt to the medium and synthesise enzymes, and growth is slow (few cells divide)
Exponential (log)Cells divide at the maximum rate; the population doubles at regular intervals, because nutrients are abundant
StationaryGrowth rate equals death rate. Nutrients run low and toxic waste accumulates
Death (decline)Death rate exceeds growth, as nutrients are used up and waste has built up

A logarithmic scale is used because the numbers cover a very large range. The exponential phase is a straight line.

Exponential growth rate constant

If a population has N0N_0 cells at the start and NN cells after nn generations:

N=N0×2nN = N_0 \times 2^n

growth rate constant, k=ntgeneration time=tn\text{growth rate constant, } k = \frac{n}{t} \qquad \text{generation time} = \frac{t}{n}

where n=log⁡N−log⁡N0log⁡2n = \dfrac{\log N - \log N_0}{\log 2}.

n=log⁡106−log⁡103log⁡2=30.301=9.97n = \dfrac{\log 10^6 - \log 10^3}{\log 2} = \dfrac{3}{0.301} = 9.97 generations. k=9.97/5=2.0k = 9.97/5 = 2.0 generations per hour (generation time 30 minutes).

Core Practical 13: growth in a liquid culture

  1. Prepare a sterile broth and inoculate with a known volume of bacteria or yeast using aseptic technique.
  2. Incubate at a constant temperature.
  3. At regular intervals, take a sample and measure its growth by turbidity (colorimeter, with a blank of sterile broth) or by dilution plating.
  4. Plot the results and identify the phases.

Take into account the safe and ethical use of microorganisms: use a non-pathogenic strain (e.g. E. coli K12 or yeast), keep the culture away from the face, and autoclave afterwards. Control the volume, temperature, aeration and starting concentration.

Test yourself10 flashcards on this chapter.Flashcards →

These notes are AI generated and may contain mistakes. Check them against your syllabus.