Physics · May / June 2025 · Paper 31 · Question 4
YPH11
As printed in the paper
The question as text
4 A student determined the speed of sound in air using the apparatus shown. wires from signal generator Not to scale loudspeaker stand air L transparent cylinder metre rule water
Read automatically from the paper; the printed page above is exact.
Show the answer and mark scheme
4(a)[2]
EITHER
Use a set square between the cylinder and metre rule to read off the scale
Or take readings perpendicular to the metre rule
Accept “take readings horizontally” or “take readings at eyelevel”
Or move the metre rule close to the cylinder
(To reduce) parallax error in reading L
Reducing “random error” is insufficient
MP2 dependent on MP1
OR
Use a set square to ensure metre rule is perpendicular to the table
Accept other valid methods to ensure metre rule is vertical
(e.g. spirit level, plumb line)
(To reduce) systematic error in L
MP2 dependent on MP1
Do not accept “parallax error” in this version
4(b)[2]
EITHER
Slowly increase and decrease the frequency, and record the frequency
“Increase frequency slowly” is not sufficient, as this is given in the
(of the loudest sound heard) in both directions
question.
Calculate the mean of these frequencies
MP2 must be linked to a relevant technique for measuring frequency
OR
Use a microphone and a CRO
(The standing wave will be produced) at maximum amplitude on the
MP2 must be linked to a relevant technique for viewing amplitude
CRO
OR
Use a sound level meter
(The standing wave will be produced) at maximum value on the screen
MP2 must be linked to a relevant technique for measuring sound
level. Ignore “loudest” “strongest” sound, as this is given in the
𝑓𝑓= ቀ
2𝐿𝐿ቁ𝑛𝑛+ 𝑘𝑘 compares to y = mx + c
𝑣𝑣
question. We are looking for some description of a measurement.
4(c)(i)[2]
There must be some link between m and the gradient
So 𝑣𝑣= 2𝐿𝐿 × 𝑔𝑔𝑔𝑔𝑔𝑔𝑔𝑔𝑔𝑔𝑔𝑔𝑔𝑔𝑔𝑔
Accept
𝑣𝑣
2𝐿𝐿 is the gradient
4(c)(ii)[5]
yaxis labelled as f / Hz and xaxis labelled as n with no unit
MP1 – labels in standard format “quantity / unit”
Sensible scales
If axes are reversed, MP2 to 4 can still be awarded
Plotting
MP2 – Scale increments in powers of 10 of “1, 2, 5” on the 2 cm
Line of best fit
(and 2 mm) lines and plots cover at least half of the paper.
MP3 – Plots accurate to ½ square (1 mm) on a sensible scale – all
correct = 2 marks, only 1 error = 1 mark, 2+ errors = 0 marks
MP4 – a single straight line that follows the trend and is balanced
4(c)(iii)[4]
Calculates gradient using large triangle
Over half the range of plots used in gradient calculation
Uses gradient =
𝑣𝑣
2𝐿𝐿
Data used should come from the line of best fit
If table data used, check those points are on the line of best fit
v between 338 and 354
5.2 − 1.0 =
1360 − 140
1220
Example of calculation
4.2 = 290.5
Gradient =
v given to 2 or 3 s.f, with unit
v = gradient × 2L = 291 × 2 × 0.595 = 346 m s−1
4(c)(iv)[2]
EITHER
Correct yintercept read from graph
Or Calculation of k using gradient/velocity and a data point
Conclusion consistent with comparing the magnitude of 2k with
MP2 must include a comparison between the values
gradient
They must be comparing the magnitude of k (so not a negative
Or Conclusion consistent with comparing the magnitude of k with
value)
½ gradient
Example of calculation
yintercept = 1360 − 291 × 5.2 = − 153
2k = 2 × 153 = 306
2k is much greater than the gradient, so the suggestion is incorrect
OR
Calculation of v using k = ½ × gradient and a data point
Conclusion consistent with comparing the calculated v for both positive
and negative k with answer from 4(c)(iii)
(Total for Question 4 = 17 marks)
Pearson Education Limited. Registered company number 872828
with its registered office at 80 Strand, London, WC2R 0RL, United Kingdom
Make a free account to save your answers and see your weak topics and ask the AI why a wrong answer is wrong.

