Note AcademyNote Academy

Physics · May / June 2025 · Paper 31 · Question 3

YPH11

As printed in the paper

The question as text

3 A student investigated the power output of a power supply using the circuit shown. power supply A V The power supply has an internal resistance.

Read automatically from the paper; the printed page above is exact.

Show the answer and mark scheme
  • 3(a)(i)[2]

    This ensures the current will be at the minimum/smallest

    “Smaller”, “less” or “lower” current is too vague, the question

    states maximum resistance and “limits current” is insufficient

    To prevent the risk of overheating

    Or to prevent a short circuit

    For components allow ammeter, power supply or variable resistor

    Or to avoid damaging the components

    Ignore “damages the circuit”.

    Accept reverse argument (e.g. minimum resistance would give the

    largest/maximum current, which would damage the ammeter)

  • 3(a)(ii)[2]

    EITHER

    There will be little/no variation in the current and potential difference for

    Ignore references to the ohmmeter

    repeat readings (at same resistance)

    Or random error would be small/negligible

    Ignore systematic error

    So repeat readings are not appropriate

    MP2 dependent on MP1

    OR

    Changes in temperature will vary the (resistance/current/p.d.) readings

    Or changes in temperature will cause random errors

    Or (analogue) ammeter/voltmeter may cause a parallax error

    Do not accept answers including a systematic error for this version

    Or repeat readings can be used to identify anomalous data

    So repeat readings are appropriate

    MP2 dependent on MP1

  • 3(b)(i)[1]

    Value between 1.5 Ω and 1.6 Ω

    𝑉𝑉2

    𝑅𝑅

  • 3(b)(ii)[2]

    Accept substitution of a power value from the graph (2 to 6W) and

    Accept use of 𝑃𝑃= 𝐼𝐼2𝑅𝑅 and 𝑉𝑉= 𝐼𝐼𝐼𝐼 for MP1

    Use of P =

    their resistance from 3(b)(i) for MP1

    Potential difference = 3 V

    Allow e.c.f. from 3(b)(i) with P = 5.6 Wfor MP2

    𝑉𝑉2

    Example of calculation

    𝑅𝑅

    𝑉𝑉= √𝑃𝑃𝑃𝑃 = √5.6 W × 1.6 Ω = 2.99 V

    P =

  • 3(c)[2]

    Advantage

    (Maximum power) would produce the maximum signal strength

    Accept “maximum intensity” for maximum signal strength

    Or (Maximum power) would produce signals which can travel further

    Ignore “transmits over a larger area” if not linked to larger distance

    Disadvantage

    (50% of the) energy will be dissipated from the circuit, so more input

    power is needed

    Or (50% of the) energy will be dissipated from the circuit, so the

    Idea that something is “heating up” is sufficient for MP2, but

    circuit/transmitter/surroundings would heat up

    “energy is wasted” is insufficient.

    (Total for Question 3 = 9 marks)

Make a free account to save your answers and see your weak topics and ask the AI why a wrong answer is wrong.