Note AcademyNote Academy

Chemistry · May / June 2022 · Paper 31 · Question 3

YCH11

As printed in the paper

The question as text

3 Cyclohexene, C6H10 , was prepared by dehydrating cyclohexanol, C6H11OH, using concentrated phosphoric(V) acid, H3PO4 . C6H11OH(l) → C6H10(l) + H2O(l) Procedure Step 1 Approximately 12 cm3 of cyclohexanol was measured into a small flask. Step 2 5 cm3 of concentrated phosphoric(V) acid was added slowly to the flask with cooling and swirling. Step 3 Some anti‑bumping granules were added to the mixture. Step 4 The flask was set up for distillation, using the apparatus shown, and the distillate was collected between 80 °C and 90 °C. water out water in heat Step 5 The distillate was transferred to a separating funnel and washed with an aqueous solution of sodium carbonate. Step 6 The crude organic product was separated from the mixture, placed in a clean separating funnel and washed with deionised water. Step 7 The organic layer was separated and dried using a suitable drying agent. Step 8 The dried organic layer was distilled, over a narrow range of temperature, to give pure cyclohexene. Substance Boiling temperature / °C Density / g cm–3 Cyclohexanol 162 0.96 Cyclohexene 83 0.81 Water 100 1.00

Read automatically from the paper; the printed page above is exact.

Show the answer and mark scheme
  • 3(a)[1]

    An answer that makes reference to the following point

    measuring cylinder

    Do not award pipette, beaker

    Ignore burette

    Ignore numbers or volumes before the measuring

    cylinder e.g. 10cm3 measuring cylinder

    Do not award measuring cup / jug

  • 3(b)[2]

    An answer that makes reference to the following points:

    the reaction is exothermic

    Do not award explosive

    cyclohexene would be lost because it is volatile /

    Allow less of the cyclohexene / product produced

    would be lost / would boil off

    has a low boiling temperature / evaporate

    Allow to prevent / reduce reaction before the

    distillation experiment takes place

    Ignore swirling to mix the reactants

    Ignore prevents evaporation of volatile liquids

    Ignore too vigorous

    Ignore references to shifting the position of

    equilibrium or rate of reaction

    Ignore increase yield

    Ignore prevents evaporation / boiling of

    cyclohexanol / solution

  • 3(c)[1]

    An explanation that makes reference to the following

    points:

    so the product is not contaminated by the reaction

    Allow so the reaction mixture / cyclohexanol does

    mixture / cyclohexanol being transferred to the

    not go into the condenser / collecting flask

    Ignore just to prevent it boiling over

    collecting flask

    Do not award to prevent ignition

  • 3(d)[2]

    An explanation that makes reference to the following

    points:

    the range starts below the boiling temperature of

    Allow only cyclohexene boils within this range /

    between 80ºC and 90ºC

    cyclohexene and finishes below that of water /

    cyclohexanol

    Ignore statements of the range and boiling

    temperatures without explanation

    a minimum amount of cyclohexanol / water /

    Allow above this range (more) water (and

    cyclohexanol) would distil across / would be

    phosphoric acid / impurities are distilled across

    collected

    Allow cyclohexanol / water will remain in the flask

    / will not be vapourised

    Or

    so cyclohexene vaporising below the boiling

    temperature is collected

  • 3(e)(i)[2]

    An answer that makes reference to the following points:

    phosphoric((V)) acid / H3PO4

    Allow (excess) acid

    Ignore (excess) H+ ions

    equation

    2 → CO2 + H2O

    2H+ + CO3

    Allow

    2H+ + CO3

    2 → H2CO3

    Allow multiples

    Ignore state symbols, even if incorrect

  • 3(e)(ii)[2]

    An answer that makes reference to the following points

    diagram of separating funnel including a tap and a

    stopper or capable of being stoppered

    two labelled layers

    organic /

    cyclohexene

    aqueous / water / sodium

    carbonate solution

    Top layer labelled organic layer, bottom layer

    labelled aqueous layer

    Ignore cyclohexanol in cyclohexene layer

    Do not award bottom layer labelled as cyclohexanol

    but allow labelled as aqueous layer containing

    cyclohexanol / water and cyclohexanol

  • 3(e)(iii)[1]

    An answer that makes reference to the following point

    ionic compounds / cyclohexanol / sodium

    Allow (excess) sodium carbonate

    Allow sodium ions / phosphate((V)) ions /

    phosphate((V))

    carbonate ions

    Ignore water

    Ignore just ‘impurities’

    Do not award phosphoric((V)) acid

    Do not award HCl / hydrochloric acid

  • 3(f)[2]

    An answer that makes reference to the following points:

    MgSO4
    it is an anhydrous (salt) (and doesn’t react)

    Allow contains no water / not hydrated

    Allow reasons why the other five are not suitable

    M2 depends on M1

  • 3(g)(i)[2]

    An answer that makes reference to the following points:

    M2 dependent on M1 or near miss

    bromine water / Br2(aq) / bromine solution

    Allow bromine / Br2(l) / Br2

    Do not award bromide

    orange to colourless

    Allow decolourises bromine / bromine water

    Allow brown to colourless

    Allow yellow to colourless

    If bromine is used do not award yellow / orange to

    Or

    colourless. M2 must be brown/redbrown to

    colourless

    potassium manganate(VII) / KMnO4 and sulfuric

    acid

    Allow potassium permanganate

    Allow acidified potassium manganate(VII)

    Do not award hydrochloric acid

    purple to colourless

    Allow purple to brown

    Allow decolourises

  • 3(g)(ii)[2]

    An answer that makes reference to the following points:

    M2 dependent on M1 or near miss

    Do not award potassium dichromate((VI))

    (addition of) phosphorus pentachloride /

    Do not award phosphorus chloride but count as near

    phosphorus(V) chloride / PCl5

    miss

    misty / steamy fumes (of HCl)

    Allow white fumes

    Ignore litmus paper test on fumes

    Do not award white gas

    Or

    (addition of) sodium
    effervescence / bubbles

    Allow white solid formed

    Allow ester formation

    addition of a carboxylic acid / named carboxylic

    acid and a strong acid / mineral acid / named strong

    acid / formula of strong acid (1)

    sweet / fruity smell (of ester) (1)

    Additional Guidanc2e

  • 3(g)(iii)[1]

    An answer that makes reference to the following points:

    (no because) PCl5 / Na reacts with water (so would

    Allow yes with or without justification if ester

    potentially give a false positive test)

    formation is used in 3(g)(ii)

    (Total for Question 3 = 18 marks)

    (Total for Paper = 50 marks)

    Pearson Education Limited. Registered company number 872828

    with its registered office at 80 Strand, London, WC2R 0RL, United Kingdom

Make a free account to save your answers and see your weak topics and ask the AI why a wrong answer is wrong.