Physics · Oct / Nov 2023 · Paper 51 · Question 15
YPH11
As printed in the paper
The question as text
* 15 A student is planning an experiment to investigate how the resistance of a thermistor changes with temperature. The student wants to use the temperature range 0 oC to 100 oC. Describe a method the student could use to determine values of resistance and temperature over this range. You should include one precaution the student should take to ensure accurate measurements. You do not need to draw a circuit diagram.
Read automatically from the paper; the printed page above is exact.
Show the answer and mark scheme
This question assesses a student’s ability to show a coherent and logically
structured answer with linkages and fullysustained reasoning.
Marks are awarded for indicative content and for how the answer is structured
and shows lines of reasoning.
The following table shows how the marks should be awarded for structure
and lines of reasoning.
Number of marks
awarded for structure
of answer and
sustained line of
reasoning
Answer shows a coherent and logical structure with
2
linkages and fully sustained lines of reasoning demonstrat
throughout
Answer is partially structured with some linkages and line
1
of reasoning
Answer has no linkages between points and is unstructure
0
Total marks awarded is the sum of marks for indicative content and the marks
for structure and lines of reasoning
IC points
IC mark
Max linkage mark Max final mark
6
4
2
6
5
3
2
5
4
3
1
4
3
2
1
3
2
2
0
2
1
1
0
1
0
0
0
0
Indicative content
IC1
Connect the thermistor to a suitable circuit with voltmeter and ammeter
Or Connect the thermistor to an ohmmeter
IC2
Place the thermistor in a water bath
Or place the thermistor in a beaker of water
IC3
Add ice to reduce the water temperature to 0oC
IC4
Heat the water and use a thermometer to measure the temperature
Or Heat the water and use a temperature sensor and datalogger to
measure the temperature
IC5
Determine the resistance R (for each temperature) using R = V/I
Or Measure the resistance (for each temperature) by reading from
ohmmeter
IC6
Stir the water (to ensure that the thermistor is at the temperature
measured by the thermometer)
Or Place the thermometer near to the thermistor (to ensure that the
thermistor is at the temperature measured by the thermometer)
Or Stop heating and wait before taking readings
Or Use small current/p.d. (to prevent it heating the thermistor)
Or Switch current off between readings
Or Read thermometer at eye level
Make a free account to save your answers and see your weak topics and ask the AI why a wrong answer is wrong.

