Note AcademyNote Academy

Physics · Oct / Nov 2020 · Paper 11 · Question 19

YPH11

As printed in the paper

The question as text

19 The transmission of electricity over long distances requires a conducting cable that is suitable to hang from supporting towers called pylons. The vertical distance from the line of support to the lowest point on the wire is called the sag. Due to the high voltages involved, the cable must maintain a minimum distance from the ground. θ sag pylon pylon

Read automatically from the paper; the printed page above is exact.

Show the answer and mark scheme
  • 19(a)(i)[1]

    The distance between pylons Or length of cable Or the

    weight/mass/density of the cable/material

  • 19(a)(ii)[3]

    See Mg = 2T sin θ Or weight (or W or Mg) is proportional

    to T sin θ

    as the sag increases, θ (or sin θ) increases (for a constant

    weight)

    (as the sag increases) sinθ increases hence T decreases
  • 19(b)(i)[2]

    Use of region of graph 0 to 300 MPa to determine the

    gradient Or tangent from origin

    Esteel = 1.5 × 1011 (Pa) to 1.8 × 1011 (Pa)

    𝟐𝟐𝟐𝟐𝟐𝟐 ×𝟏𝟏𝟏𝟏𝟔𝟔 𝑷𝑷𝑷𝑷

    Example of calculation

    𝟎𝟎.𝟎𝟎𝟎𝟎𝟎𝟎𝟎𝟎

    Esteel =

    = 1.53 × 1011 Pa

    𝐹𝐹

  • 19(b)(ii)[2]

    𝐴𝐴 to obtain the stress

    Use of σ =
    stress = 73 MPa

    Example of calculations

    F = 0.62 N m−1× 270 m = 167.4 N

    0.62 N m−1 ×270 m

    2.3 × 10−6 m2

    σ =

    σ = 72.8 MPa

    METHOD 1

  • 19(b)(iii)[3]

    Use of graph to obtain the strain in steel

    𝑙𝑙(for steel ∆e = 0.14 m)

    ∆𝑒𝑒

    Or use of Young Modulus

    Use of ε =
    Comparison of the two extensions/strains

    e.g. the extension/strain of aluminium is larger than that of

    steel, so steel is used to reduce the (total) extension/sag

    Or

    Comparison of two strains/extensions e.g. lower strain for

    steel so stiffness of cable increased to reduce (total)

    extension/sag

    ∆𝑒𝑒

    METHOD 2

    𝑙𝑙 to find strain (for extension of 0.95 m)

    Use of ε =
    Use of graph to obtain the stress in aluminium and steel.
    Comparison of two stresses (e.g. greater stress required for

    steel) so stiffness of cable increased to reduce (total)

    extension/sag

    Example of calculation

    Read off strain (when stress is 70 MPa) on Steel graph

    (0.0005)

    For Steel, Δe = 0.0005 × 270 m = 0.14 m

    Pearson Education Limited. Registered company number 872828

    with its registered office at 80 Strand, London, WC2R 0RL, United Kingdom

Make a free account to save your answers and see your weak topics and ask the AI why a wrong answer is wrong.