Note AcademyNote Academy

Physics · Oct / Nov 2024 · Paper 62 · Question 4

0625

As printed in the paper

The question as text

0625/62/O/N/24 © UCLES 2024 [Turn over 4 Hot water is poured into a glass beaker and allowed to cool down. Plan an experiment to investigate how the rate at which the water cools depends upon the diameter of the water surface exposed to the air. You are provided with: • a supply of hot water • a set of glass beakers of different sizes • a measuring cylinder. You may use any other common laboratory apparatus. In your plan, include: • any other apparatus needed • a brief description of the method, including what you will measure and how you will make sure your measurements are accurate • the key variables you will control • a results table to record your measurements (you are not required to enter any readings in the table) • how you will process your results to reach a conclusion. You may include a labelled diagram if you wish.

Read automatically from the paper; the printed page above is exact.

Show the answer and mark scheme

MP1

additional apparatus

stopwatch and thermometer and ruler / measuring tape / callipers

MP2

method

MP3

time hot water (in beaker) cooling

repeat using beakers of different diameter / size

MP4

control variables

one from:

volume / mass of water

initial temperature of the water / beaker

time of cooling or the same temperature decrease

MP5

results table

columns for diameter / d and time / t or diameter / d and temperature / θ

with correct units

MP6

conclusion

plot a graph of diameter vs time /

plot a graph of diameter vs temperature (decrease) /

plot a graph of diameter vs rate of cooling /

plot graphs of temperature against time (for each beaker) /

compare the results to see if / how the diameter affects the rate of cooling /

compare the temperature decreases – largest decrease gives the greatest rate /

compare the times – least time gives the greatest rate /

calculate the rate of temperature decrease for each beaker and compare

MP7

additional point (one from):

another control variable stated

at least five sets of data taken

repeat each measurement and take an average

Q2(f)(i) Symbol for variable resistor:

The box must be a rectangle, not a square.

The arrow must lie tilted between the longer sides. It doesn’t matter which way it tilts, or which way up it is.

The arrowhead must emerge from the rectangle. The tail of the arrow must at least reach the opposite side of the

rectangle, but do not penalise if it stops there.

The two lines showing connection to the rest of the circuit are not required but if present must be correct.

This type of arrowhead is also acceptable. BOD

NBOD

NBOD

The following symbols are all incorrect:

Make a free account to save your answers and see your weak topics and ask the AI why a wrong answer is wrong.