Chemistry · Oct / Nov 2024 · Paper 61 · Question 3
YCH11
As printed in the paper
The question as text
3 Ethanedioic acid, (COOH)2.xH2O , in solution is an acidic bleach for wood. A student determined the value of x in a sample of ethanedioic acid by titration with potassium manganate(VII) solution. 2MnO4 –(aq) + 16H+(aq) + 5C2O4 2–(aq) → 2Mn2+(aq) + 10CO2(g) + 8H2O(l) Procedure Step 1 A sample of 1.27 g of the solid acid was dissolved in deionised water to make 250.0 cm3 of solution. Step 2 25.0 cm3 of the ethanedioic acid solution was transferred to a conical flask, 25 cm3 dilute sulfuric acid was added and the mixture warmed to 60 °C. Step 3 The mixture was titrated with potassium manganate(VII) solution of concentration 0.0203 mol dm–3.
Read automatically from the paper; the printed page above is exact.
Show the answer and mark scheme
3(a)(i)[3]
A description that makes reference to three of the following
points:
Allow the use of a funnel to transfer solid to flask
add deionised/distilled water to the solid (in a beaker)Do not award conical flask/measuring cylinder
(transfer solution to) a volumetric flask with washingsM3 depends on the use of a volumetric flask in M2
make up to the mark (with deionised/distilled water) andinvert/mix
An explanation that makes reference to two of the following
3(a)(ii)[2]
points:
volume measured using a measuring cylinder is lessAllow reverse argument
accurate/precise than a (volumetric) pipette
the ethanedioic acid volume/amount is stoichiometric/used in the titration calculation/is a limiting factor
the sulfuric acid acidifies the mixture/ provides hydrogenIgnore references to a catalyst
ions for the reaction/must be in excess
An answer that makes reference to the following point:
3(a)(iii)[1]
the titration is selfindicating / the endpoint is when theAllow colourless to pink
mixture becomes purple/pale pink
Allow reactants and products are different colours
Do not award pink to colourless
An explanation that makes reference to the following points:
3(a)(iv)[3]
the reaction has a high activation energy / rate is slow (atroom temperature)
Allow the reaction is exothermic
the reaction will be faster at a higher temperature/heat isneeded to supply the activation energy
Allow Mn2+ ions speed up the reaction
Mn2+ ions are produced (in the titration reaction)(which) act as a catalyst/ the reaction is autocatalysed
Example of calculation
3(a)(v)[4]
mol of manganate(VII) in titre19.90 ∈ 0.0203 ÷ 1000 = 4.0397 ∈10−4 / 0.00040397 (mol)
mol ethanedioic acid in 250 cm30.00040397 ∈ 5/2 ∈ 10 = 1.00993 ∈10−2 / 0.010099 (mol)
1.27 – (0.010099 ∈ 90) = 0.36107(g)
mass water in solid0.0101 : 0.36107 ÷ 18
mole ratio of ethanedioic acid : water0.0101 : 0.020059 / 2.0059 ∈10−2
1: 2 so x=2
Alternative M3
Alternative M3: molar mass of ethanedioic acid
1.27 ÷ 0.010099 = 125.75
125.75 – 90= 35.751
Alternative M4: moles water
35.751 ÷ 18 = 1.9862 ~ 2 so x=2
Correct answer with some working scores 4
Ignore SF for M1,M2 and M3
Do not award M4 if answer is not an integer
3(b)[3]
An answer that makes reference to three of the following
points:
Method 1
titrate (a solution of) ethanedioic acid with (aqueous)sodium hydroxide (noting the volume NaOH added at
the end point)
Ignore colour change even if incorrect
using thymol blue as an indicatorAllow: add half the titre volume of NaOH to a different
add (25cm3) ethanedioic acid to the mixture and25cm3 sample of ethanedioic acid, and measure the pH
measure the pH using a pH meter
using a pH meter
Method 2
add (small portions of) sodium hydroxide, noting thepH after each addition
This could be determined by using any indicator but not
until the first neutralisation/ sharp rise in pH has beenphenolphthalein
observed
plot a graph of pH (against the volume of alkaliadded) and determine the point of half neutralisation
(Total for Question 3 = 16 marks)
An explanation that makes reference to three of the following
Make a free account to save your answers and see your weak topics and ask the AI why a wrong answer is wrong.

