Note AcademyNote Academy

Chemistry · Oct / Nov 2022 · Paper 61 · Question 4

YCH11

As printed in the paper

The question as text

4 Ethyl butanoate reacts with water. CH3CH2CH2COOCH2CH3 + H2O → CH3CH2CH2COOH + CH3CH2OH A student investigated the kinetics of this reaction. Procedure Step 1 50 cm3 of ethyl butanoate was heated under reflux with a very large excess of water. Step 2 After 30 minutes a sample of known volume was removed from the reaction mixture and placed in a conical flask. Step 3 This sample was titrated using aqueous sodium hydroxide solution. Step 4 Further samples were removed from the refluxing mixture at 30‑minute intervals. Each sample was titrated until the titres of three consecutive samples were the same.

Read automatically from the paper; the printed page above is exact.

Show the answer and mark scheme
  • 4(a)[1]

    An answer that makes reference to the following point:

    Allow syringe

    (volumetric / bulb / graduated) pipette

    (and pipette filler / safety filler)

    Do not award dropping or teat pipette /

    burette / measuring cylinder / gas syringe

    Acceptable Answers

  • 4(b)(i)[1]

    An explanation that makes reference to the following point:

    Vfinal – Vt is proportional to [CH3CH2CH2COOCH2CH3]

    Allow Vfinal – Vt is proportional to [reactant]

    Allow a product is being monitored (rather

    than a reactant)

    Ignore just ‘volume if proportional to

    concentration’

  • 4(b)(ii)[2]

    An answer that makes reference to the following points:

    Example of calculation

    calculation of 1 halflife

    t1 = 0 – 0.70 = 0.70 (h)

    t2 = 1.40 – 0.70 = 0.70 (h) /

    calculation of second halflife which is constant /

    has a similar value (and so first order)

    t3 = 2.1 – 1.40 = 0.70 (h)

    Allow half lives in range 0.75 – 0.65 (h)

    Allow correct conversion into minutes so range is

    45 – 39 minutes/min

    Two correct half lives without any working and

    reference to constant value scores (1)

    Some correct working must be shown on the graph

    and even small dashes on the x axis is sufficient

  • 4(b)(iii)[2]

    An explanation that makes reference to the following

    points:

    Either

    Allow reactants need to be equimolar to determine

    no

    and

    overall order /

    (additional experiment with ester in excess is needed)

    either

    as order (determined) is with respect to

    to find order with respect to water

    ethyl butanoate only

    or

    water is a reactant

    because water is in excess

    Or

    yes, because water is in (very) large excess
    so (concentration of water) has no effect on the rate

    of reaction

  • 4(b)(iv)[4]

    tangent drawn at time = 2 hours

    Standalone mark but absence of results in loss of M2 and M3 unless

    data points used

    Example of calculation

    changes in x and y determined

    change in y = (23 – 0) = 23 (cm3) change in x = (2.8 – 0) = 2.8 (h)

    Allow range 22 − 24 for y, 2.7 − 2.9 for x

    calculation of rate

    (−)23 ÷ 2.8 = (−) 8.21

    Allow range (−) 7.59 – 8.89 which scores M2 and M3

    Mark consequentially on values from M2

    Allow cm3 /h and allow (per) hr or hour(s) for h

    Ignore the absence of negative sign given in front of rate

    Ignore SF except 1 SF

    Allow correct conversion into other units

    correct units of cm3 h−1

    e.g. (−) 0.1369 cm3 min–1 or cm3 /min

    or (−) 2.282 x 10−3 cm3 s–1 or (−) 0.002282 cm3 s–1

    Range of (−) 0.1265 – 0.1482 cm3 min–1 for M3 and M4

    No TE on units from an incorrect calculation expression

    Do not award units m for min

    M4 is a standalone mark but only allow use of minutes if values used

    are converted from hours

    Use of data points at 2h scores M3 and M4 only for

    (−) 3.5 cm3 h−1 and or all other values only award M4

    If no tangent then only award M4 unless use of data points as above

  • 4(c)[2]

    An answer that makes reference to the following points:

    this suggestion will quench the reaction / slow down the reaction

    Allow stop the reaction

    (as reaction mixture at 100° C)

    Ignore just reference to cooling

    Do not award if slowing of reaction

    is related to other reaction/

    slow the titration reaction(s)

    Either

    it makes no difference (to validity) because the reaction is already

    very slow / takes 4 hours / no catalyst is used

    or

    Allow reference to validity improved

    it will make a difference/improve (validity) because otherwise the

    reaction will continue producing butanoic acid

    because acid concentration is

    fixed/unchanged

    (at a significant rate)

    or

    because otherwise the reaction will

    continue so the titre will change

    Do not award reference to ice

    increasing the volume and decreasing

    the concentration

    TOTAL FOR PAPER = 50 MARKS

    Pearson Education Limited. Registered company number 872828

    with its registered office at 80 Strand, London, WC2R 0RL, United Kingdom

Make a free account to save your answers and see your weak topics and ask the AI why a wrong answer is wrong.