Note AcademyNote Academy

Chemistry · May / June 2021 · Paper 61 · Question 2

YCH11

As printed in the paper

The question as text

2 This question concerns the laboratory preparation of tetraamminecopper(II) sulfate-1-water, Cu(NH3)4SO4.H2O. Procedure Step 1 Weigh between 2.1 g and 2.3 g of hydrated copper(II) sulfate, CuSO4.5H2O, in a boiling tube. Add 8 cm3 of distilled water and place the boiling tube in a hot water bath. Stir the mixture until the crystals have dissolved. Step 2 Working in a fume cupboard, slowly pour 5 cm3 of concentrated aqueous ammonia into the boiling tube. Stir until a clear solution is obtained. Step 3 Measure 12 cm3 of ethanol into a 100 cm3 conical flask and add the contents of the boiling tube from Step 2. Stopper the flask and swirl the contents before placing the flask in an ice bath. Allow the mixture to stand until crystals of Cu(NH3)4SO4.H2O have formed. Step 4 Filter the crystals obtained in Step 3 under reduced pressure, using a Buchner funnel and flask. Step 5 Pour 5 cm3 of cold ethanol over the crystals in the funnel. Step 6 Using a spatula, transfer the crystals to a filter paper on a watch glass. Press a second piece of filter paper on the crystals, to dry them as much as possible. Step 7 Transfer the crystals to a dry, pre-weighed sample bottle and reweigh.

Read automatically from the paper; the printed page above is exact.

Show the answer and mark scheme
  • 2(a)[1]

    Any one of:

    quicker

    do not need the accuracy of a graduated pipette

    Allow volume is approximate/to 1SF

    Ignore there are not 8 cm3 pipettes

    Ignore water is in excess

  • 2(b)[1]

    dark blue

    Allow deep/royal for dark

    Do not award ‘just’ blue

    Do not award mention of any other colour

    Ignore any reference to the formation of a

    precipitate that subsequently dissolves

  • 2(c)[1]

    Accept poisonous/corrosive/irritant for toxic

    ammonia/NH3 (gas) is toxic

    Ignore harmful/dangerous/health hazard

  • 2(d)[1]

    the tetraamminecopper(II) sulfate1water/

    Allow product/salt/complex/crystals/

    Cu(NH3)4SO4.H2O is less soluble in (aqueous)

    precipitate/solid/it for

    ethanol (than water so crystallises)

    tetraamminecopper(II) sulfate1water

    Allow insoluble in ethanol

  • 2(e)[3]

    A diagram showing:

    Example of diagram:

    Buchner funnel

    Funnel must show perforations/holes below the filter paper

    and

    Allow any properly shaped Buchner funnel

    labelled filter paper (1)

    Allow sintered glass funnel

    Do not award porous paper

    Do not award fluted filter paper

    Allow conical flask with side arm

    Buchner flask

    and

    (rubber) seal (1)

    Allow vacuum/pump/reduced pressure/aspirator/suction

    (side arm with) vacuum pump (1)

    Ignore just water tap

    Do not award pressure out/negative pressure

  • 2(f)(i)[1]

    to remove (soluble) impurities

    Ignore to wash the crystals

  • 2(f)(ii)[1]

    hot ethanol would dissolve the tetraamminecopper(II)

    Allow product/salt/complex/crystals/

    sulfate1water/Cu(NH3)4SO4.H2O

    precipitate/solid/it for

    tetraamminecopper(II) sulfate1water

    OR

    so only a very small/the minimum amount of

    Allow just so it does not dissolve

    tetraamminecopper(II) sulfate1water/

    Allow just it is less soluble in cold ethanol

    Cu(NH3)4SO4.H2O dissolves (in cold ethanol)

    Do not award insoluble in ethanol

    Ignore just to minimise loss of product

  • 2(g)(i)[3]

    Example of calculation:

    Mr values of CuSO4.5H2O and Cu(NH3)4SO4.H2O (1)

    Mr CuSO4.5H2O = 249.6

    Allow 249.5

    Mr Cu(NH3)4SO4.H2O = 245.6

    Allow 245.5

    mols of CuSO4.5H2O

    Mols CuSO4.5H2O

    = 2.17 (= 0.0086939 / 8.6939 × 10−3)

    and

    249.6

    mols Cu(NH3)4SO4.H2O

    Mols Cu(NH3)4SO4.H2O

    = 2.54 (= 0.010342 / 1.0342 × 10−2)

    OR

    245.6

    theoretical mass Cu(NH3)4SO4.H2O (1)

    Theoretical mass Cu(NH3)4SO4.H2O

    = 0.0086939 × 245.6 = 2.1352 (g)

    TE on M1

    percentage yield to 2SF or 3SF (1)

    % yield = 0.010342/0.0086939 × 100

    = 118.96

    = 119%/120%

    OR

    % yield = 2.54/2.1352 × 100

    = 119%/120%

    Allow 119.0%

    TE on M2

    Correct answer with some working scores (3)

    Just 2.54/2.17 × 100 = 117%/120% scores (0)

    Just 2.17/2.54 × 100 = 85.4%/85% scores (0)

    If no other mark awarded, Mr and mols of

    CuSO4.5H2O / Cu(NH3)4SO4.H2O scores (1)

  • 2(g)(ii)[1]

    An answer which makes reference to the

    following point:

    Allow wet/not properly dried/some ethanol/water remains

    damp crystals

    Allow product etc for crystals

    Ignore just impurities

    Do not award it is a hydrated salt/has water of crystallisation

    (Total for Question 2 = 13 marks)

Make a free account to save your answers and see your weak topics and ask the AI why a wrong answer is wrong.