Chemistry · May / June 2021 · Paper 51 · Question 21
YCH11
As printed in the paper
The question as text
21 Iron Chemistry Iron is a typical transition metal. Due to the similar energies of the 3d and 4s electrons, iron forms compounds in a number of oxidation states. Iron(II) and iron(III) are the most common oxidation states, and iron(III) is the most stable. Iron ions form many complexes, including that in haemoglobin which is responsible for oxygen transport in the blood of most vertebrates. The haemoglobin-iron complex with oxygen is responsible for the red colour of blood. Iron(III) ions may be detected in solution by the addition of thioglycolic acid (HSCH2COOH). All the water ligands of the iron(III) ion are replaced giving a complex with an intense red colour which can be detected in very low concentrations. The complexes of iron(II) and iron(III) usually have a coordination number of six and are octahedral but the chloro complexes have a coordination number of four and are tetrahedral. Iron and its compounds can act as catalysts. The element catalyses the Haber process, acting as a typical heterogeneous catalyst. However, the compounds and complexes of iron are usually homogeneous catalysts.
Read automatically from the paper; the printed page above is exact.
Show the answer and mark scheme
21(a)[2]
An explanation that makes reference to the following points
Ar may be given as 1s2 2s2 2p6 3s2 3p6
the electronic structure of Fe(II) is [Ar]3d6 and Fe(III) is [Ar]3d5 (1)Allow just Fe(II) is 3d6 and Fe(III) is 3d5
3d5 is more stable than 3d6 because the 3d6 subshell has two pairedAllow halffilled subshell is more stable
electrons which results in repulsion /pairing of electrons is (energetically)
Allow 1 electron in each orbital is stable
less favourable (1)
If no other mark is scored, just ‘Fe(III) has a
halffilled 3d subshell scores (1)
Allow use of ‘orbital’ or ‘(quantum) shell’
for subshell
21(b)(i)[1]
Fe2+(g) → Fe3+(g) + e(−)Allow Fe2+(g) − e(−) → Fe3+(g)
Accepte(−)(g)
21(b)(ii)[3]
An answer that makes reference to the following points
These marks may be awarded if a labelled
M1
Hess cycle is used
conversion of iron(II) / Fe2+to iron(III)/ Fe3+requires 2958 kJ mol−1OR
conversion of iron(II) / Fe2+to iron(III)/ Fe3+requires (large amounts
of ) energy
OR
conversion of iron(II) / Fe2+to iron(III)/ Fe3+is (very) endothermic (1)
M2
this energy is recovered by hydration (which is exothermic) (1)M3
the hydration of iron(III) / Fe3+ is more exothermic than iron(II) / Fe2+and
because the iron(III) has a greater charge (1)
Accept ‘charge density’ for charge
Ignore smaller ionic radius
An answer that makes reference to the following points
21(c)[3]
the energy difference between the two sets of (3)d orbitalsAllow the different energy levels of the (3)d
subshell
is different (1)
Do not award orbital for orbitals
Do not award (quantum) shell for subshell
because the ligands / ions are different (1)Ignore just ‘complexes are different’
so radiation / light / quanta absorbed from different regions of the visibleAccept
spectrum (1)
different radiation / light frequencies
or
different radiation / light wavelengths
transmitted / reflected
Do not award radiation / light emitted
Example of calculation
21(d)(i)[4]
Method 1
log(39.8) = 1.60
conversion of % transmittance into log(% transmittance) (1)[Fe] = 0.44 (mg dm−3) (allow 0.42—0.46)
use of the graph to obtain a value for the concentration ofiron in mg dm−3(1)
calculation of the mass of iron in 500 cm3 of iron solution which0.5 x 0.44 = 0.22 mg (in 500 cm3 / 20g)
is also the mass of iron in 20 g of sodium carbonate (1)
Accept 0.210.23 (mg)
OR
0.00022 / 2.2 x 10−4 g (in 500 cm3 / 20g)
conversion of the mass Fe in 20 g to ppm (1)(106 x 2.2 x 10−4) ÷ 20= 11 ppm
Method 2 (M1 and M2 as above)
calculation of concentration of sodium carbonate (1)= 20 x 1000/ 500÷1000
= 40000 mg dm−3
calculation of the ppm of Fe in 40000 mg of sodium carbonate (1)ppm = 0.44 x 106/40000 = 11 ppm (<20ppm)
21(d)(ii)[2]
(thioglycolic acid is a) bidentate (ligand) (1)because there are three ligands per complex ion and the coordinationAllow three ligands replace six
number of Fe3+ is (usually) six
(monodentate) water ligands
OR
Accept S and O atoms
can form dative bonds using the lone pairs on the SH and the COOH
Ignore just ‘forms two dative bonds’
groups (1)
/ ‘3 ligands form 6 dative bonds’
Do not award two dative covalent bonds
from COOH
21(e)(i)[1]
catalyst and reactants are in the same phaseAccept ‘same state’
Allow all species are in aqueous solution
Allow ‘It’ is in the same phase / state as the
reactants
Ignore reference to products
Examples of equations
21(e)(ii)[2]
equation for oxidation of iron(II) by peroxodisulfate (1)S2O82− + 2Fe2+→ 2SO42− + 2Fe3+
equation for oxidation of iodide ions by iron(III) (1)2I− + 2Fe3+→ I2 + 2Fe2+
Allow multiples / equations in any order
Ignore state symbols even if incorrect
Two unbalanced equations with all species
correct scores (1)
21(e)(iii)[1]
uncatalysedreaction involves two negatively charged ions reactingIgnore general definitions of catalysts
and
catalysed steps involve oppositely charged ions reacting (which is
kinetically more favourable / lowers the activation energy)
chloride ions are large so steric hindrance is too great for six ligands toAllow just ‘chloride ions are large’
21(f)[1]
Allow chlorine ligands are (too) large
coordinate around the central ion
Do not award chlorine atoms
Ignore reference to repulsion between
negative chloride ions
(Total for Question 21 = 20 marks) Total for Section C = 20 marks
Total for paper = 90 marks
Pearson Education Limited. Registered company number 872828
with its registered office at 80 Strand, London, WC2R 0RL, United Kingdom
Make a free account to save your answers and see your weak topics and ask the AI why a wrong answer is wrong.

