Chemistry · Oct / Nov 2020 · Paper 61 · Question 3
YCH11
As printed in the paper
The question as text
3 A group of students carried out an experiment to determine the rate equation for the reaction between bromide and bromate(V) ions in acid conditions. The equation for this reaction is −(aq) + 5Br−(aq) + 6H+(aq) → 3Br2(aq) + 3H2O(l) BrO3 Procedure (to determine the order of reaction with respect to bromate(V) ions) Step 1 Measure 10.0 cm3 of aqueous phenol solution into a boiling tube and add five drops of methyl red indicator. The mixture turns yellow (the alkaline colour of methyl red). Step 2 Add 5.0 cm3 of aqueous potassium bromide and 10.0 cm3 of dilute sulfuric acid to the boiling tube. The mixture turns red (the acid colour of methyl red). Step 3 Measure 15.0 cm3 of aqueous potassium bromate(V) into a second boiling tube. Step 4 Mix the contents of the two boiling tubes and start a timer. Step 5 Record the time (t) when the colour of the methyl red is bleached from red to colourless by excess bromine. Step 6 Repeat the experiment using different volumes of aqueous potassium bromate(V), adding distilled water so that the total volume of the reacting solution is always 40.0 cm3.
Read automatically from the paper; the printed page above is exact.
Show the answer and mark scheme
3(a)[1]
phenol is corrosive and wearing glovesAllow caustic
Allow phenol is toxic by skin absorption so
wear gloves
Ignore irritates the skin
Ignore use of fume cupboard
Do not award toxic so use fume cupboard and
corrosive so use gloves
3(b)[2]
An answer that makes reference to the following points:
Ignore reference to white precipitate (of
2,4,6tribromophenol)
phenol reacts (rapidly) with the bromine (formed inAllow phenol removes the bromine
the reaction)
Do not award phenol is a solvent
when all the phenol is used up the (excess)bromineAllow indicator decolourises when all the
bleaches the methyl red indicator (marking a fixed
phenol has reacted / is used up
point in the progress of the reaction)
3(c)[1]
use a white card / white backgroundAllow any position of the white card (etc)
Ignore adding more indicator / increased conc
Do not award use of a cross (on white card)
Do not award use of a colorimeter
3(d)(i)[1]
so the volume (of BrO3−(aq)) is proportional toAllow equal / equivalent to for proportional
concentration
Ignore fair test
3(d)(ii)[3]
suitable choice of scale andPoints plotted together with the origin (if included but not
correct choice of axes
required) must cover at least 50% of the graph in both directions
1/t on vertical axis
axes labelled, with unitsIgnore punctuation errors e.g. (cm3) instead of / cm3
all six points plotted correctlyand best fit line (through the
origin)
COMMENT
Mark the plotting and BFL by impression
but points 1,2 5 and 6 should be on the
line with 3 slightly above the line and 4
slightly below.
If the scale is nonlinear only M2 is
available
3(d)(iii)[1]
Allow
first order (with respect to bromate(V) ions)first order (with respect to bromate(V) ions)
and
and
because as the concentration / volume (of
because the graph ((of 1/t ∝ rate) v volume
BrO3−) doubles, the rate doubles.
of BrO3− (∝ concentration)) is a straight line (through
Or
the origin)
because as the concentration / volume (of
BrO3−) doubles, the time halves.
Ignore
rate increases as concentration of BrO3−
increases
because rate proportional to concentration of
BrO3−
3(d)(iv)[1]
the methyl red is decolourised early in the reactionAccept this shown on a sketch graph
when the concentration of reactant vs time graph is
(almost) linear so the gradient of the tangent is the
Allow assumes that the reaction rate is
constant for a particular run using conc v time
same as the (change in) concentration / time
graph as shown on left
Example of possible graph
do not award just ‘concentration is
proportional to time’
3(d)(v)[2]
An explanation that makes reference to the following
points:
Ignore references to experimental uncertainty
Allow
the portion need not be discardedthe portion need not be discarded
and
and
as the data is plotted on a graph, the actual
if the volume is known
volume of the BrO3− solution is not important
(provided the (accurate) volume is known)
but the volume of water added must changeor the total volume of the solution must still
from 7.0 cm3 to 6.5 cm3
be kept at 40 cm3
If no other mark is scored, ‘portion should be
discarded and because the total volume will
have changed’ scores (1)
3(e)(i)[1]
the burette would transfer the liquid too slowly (so theAccept reverse arguments
start time would be inaccurate)
Accept
if a burette is used the reaction will start
before all the KBrO3 is added.
Allow
if a burette is used the reaction will start
immediately so difficult to measure the time
3(e)(ii)[2]
Ignore reference to measurement error
15.0 cm3 (of the BrO3−) is the largest volume so itAllow just ‘this is the largest volume’
will have the lowest (percentage) uncertainty
Allow just ‘no water added’
no water is used so this (volume measurementAllow only 3 volumes measured
uncertainty) is eliminated
3(f)[2]
An answer that makes reference to the following points:
Allow H2SO4 for H+ ions
repeat the experiment for (various concentrationsof) Br− ions and (then for) H+ ions
Allow concentration for volume
varying volume of each, (adding the appropriateIf no other mark is scored
volume of water and) keeping all other volumes
Repeat experiment varying the volume of Br−
constant
varying the volume of Br−ion solution and
keeping volume of BrO3 constant scores (1)
(Total for Question 3 = 17 marks)
Make a free account to save your answers and see your weak topics and ask the AI why a wrong answer is wrong.

