Note AcademyNote Academy

Chemistry (AS & A Level) · Oct / Nov 2025 · Paper 54 · Question 2

9701

As printed in the paper

The question as text

A student uses the following method to investigate the kinetics of the reaction between iodine and tin to produce tin(IV) iodide, Snu4. step 1 Rinse a block of tin with distilled water and then rinse it with propanone. step 2 Place 50 cm3 of a 0.400 mol dm–3 solution of iodine dissolved in methylbenzene in a 100 cm3 beaker. step 3 Suspend the block of tin from a three decimal place balance as shown in Fig. 2.1. Start a timer. step 4 Record the balance reading every 100 seconds. block of tin wire iodine dissolved in methylbenzene balance 4.979 Fig. 2.1

Read automatically from the paper; the printed page above is exact.

Show the answer and mark scheme
  • 2(a)(i)[1]

    to increase the rate of drying / removal of (distilled) water 1

  • 2(a)(ii)[1]

    iodine is not (very) soluble (in water) 1

  • 2(a)(iii)[1]

    mass change is (too / very) small 1

  • 2(a)(iv)[1]

    repeat without any iodine 1

  • 2(b)[1]

    time / s mass of tin reacted / g 0 0.000 100 0.069 200 0.120 300 0.218 400 0.291 500 0.359 1

  • 2(c)(i)[2]

    M1 points plotted correctly centre of all crosses should be on line for × value. y value should be on the line for point 1, 3 point 2, 6 – just below line / on line 4 – midway between two lines 5 – just above line / on line 1 M2 straight line of best fit drawn 1

  • 2(c)(ii)[1]

    most anomalous point circled (expected to be at time 200 s, point 3, below line of best fit) AND the balance/mass reading was taken before 200 s / too early 1

  • 2(d)[2]

    M1 two acceptable coordinates from line of best fit expressed in the form (x,y). M2 gradient correctly calculated from points listed for M1. answer correctly rounded to 3 significant figures.

  • 2(e)(i)[1]

  • 2(e)(ii)[1]

    [I2] 1

  • 2(e)(iii)[2]

    M1 no AND the rate of reaction is proportional to the concentration of iodine / a conclusion based on calculations done for M2 1 M2 explained using actual values from columns 3 and 4 in Table 2.2 1 Working for answers 1 (a) n(MnSO4

    H2O) = c × V = 2.3 × 0.1 = 0.23 mol mass MnSO4
    H2O = 0.23 × 169.0 = 38.87 g 1 (f) (i) n(S2O32-) = (13.10 × 0.001) / 1000 = 1.31 × 10–5 mol n(I2) in 25.00 cm3 of solution Z = n(S2O32–)/2 = 6.55 × 10–6 mol 1 (f) (ii) n(O2) in 25.00 cm3 of Z = (f) (i) / 2 = 3.275 × 10–6 mol n (O2) in 500 cm3 of Z = 3.275 × 10-6 × 500 / 25 = 6.55 × 10–5 mol 1 (f) (iii) n(O2) in 1dm3 of lake water = (f) (ii) × 1000 / 250 = 2.62 × 10–4 mol dissolved oxygen content = (2.62 × 10–4 × 32.0 × 1000) = 8.38 mg dm–3

Make a free account to save your answers and see your weak topics and ask the AI why a wrong answer is wrong.