Chemistry (AS & A Level) · May / June 2025 · Paper 51 · Question 1
9701
As printed in the paper
The question as text
9701/51/M/J/25 © UCLES 2025 1 Grignard reagents have the general formula RMgX, where R is a hydrocarbon group and X is a halogen. The Grignard reagent C6H5MgBr is used as an intermediate in the reaction between bromobenzene, C6H5Br, and ethanal, CH3CHO, to prepare 1-phenylethanol, C6H5CH(OH)CH3. An organic solvent, ethoxyethane, is used. The equations for the three reactions that take place during the preparation are shown. reaction 1 Mg + C6H5Br v C6H5MgBr reaction 2 C6H5MgBr + CH3CHO v C6H5CH(CH3)OMgBr reaction 3 C6H5CH(CH3)OMgBr + H+ v C6H5CH(OH)CH3 + Mg2+ + Br – The preparation involves the following steps. step 1 Set up the apparatus shown in Fig. 1.1 with approximately 1.25 g of Mg powder and 5 cm3 of ethoxyethane in the round-bottomed flask. step 2 Add 0.0500 mol of liquid C6H5Br to the round-bottomed flask dropwise using the tap funnel. Leave until reaction 1 is complete. step 3 Dissolve 3.00 cm3 of CH3CHO in 15 cm3 of ethoxyethane and add this solution to the round-bottomed flask using the tap funnel. Leave until reaction 2 is complete. step 4 Remove the condenser, tube Y and the tap funnel from the round-bottomed flask. step 5 Add 40 cm3 of dilute hydrochloric acid, HC! (aq), to the round-bottomed flask so that reaction 3 takes place. step 6 Transfer the contents of the round-bottomed flask to a separating funnel. Allow the liquids to settle so that two layers are formed. step 7 Open the tap of the separating funnel and run the lower layer into a beaker labelled A. Run the upper layer into a beaker labelled B. step 8 Allow the ethoxyethane to evaporate from the beaker containing C6H5CH(OH)CH3. solid Z tube Y tap funnel condenser round-bottomed flask Fig. 1.1 Some relevant data are shown in Table 1.1. Table 1.1 substance density / g cm–3 boiling point / C hazard bromobenzene 1.50 156 flammable, toxic, skin irritant distilled water 1.00 100 non-hazardous ethoxyethane 0.714 35 flammable, toxic ethanal 0.788 21 flammable, eye and respiratory irritant 1-phenylethanol 1.01 204 flammable, toxic, eye irritant
Read automatically from the paper; the printed page above is exact.
Show the answer and mark scheme
1(a)[2]
M1 bromobenzene is a skin irritant M2 toxic gas(es) (are produced)
1(b)(i)[1]
warm in an oven
1(b)(ii)[1]
fractional distillation
1(c)(i)[1]
arrow pointing inwards at lower entry to condenser with label ‘water in’
1(c)(ii)[1]
to prevent water getting into the apparatus
1(c)(iii)[1]
to avoid pressure build up in the apparatus
1(d)[2]
M1 order of weighing weighing boat + Mg is weighed weighing boat is weighed after Mg is transferred M2 table + units / g 1 Mass of boat + Mg (before transfer) 2 Mass of boat (+ residue of Mg) (after transfer) Mass of Mg powder (transferred)
1(e)[1]
5.23 cm3
1(f)[1]
to prevent the reaction becoming too violent
1(g)[1]
hydrochloric acid is in excess
1(h)[1]
beaker B AND ethoxyethane is less dense than water
1(i)(i)[2]
1(i)(ii)[1]
Make a free account to save your answers and see your weak topics and ask the AI why a wrong answer is wrong.

